Extra wide to allow footing slab separation which will help reduce cracks in basement floors.
Waterguard drainage channel system.
Creates thermal break between footing and basement floors.
This channel collects water from the wall floor joint and directs it to the sump chamber.
As water is collected in the waterguard drain it will work it s way down to the sump pump pit to be properly discarded.
The drainage channel is hidden beneath a layer of concrete.
Only the top edge of the wall flange is visible so you ll hardly know it s there.
The waterguard sub floor drainage system has a patented profile that includes.
This cleverly designed component connects the waterguard channel to the sump pit and creates the flow of water along the horizontally laid waterguard channel.
Waterguard is a registered trademark for the engineering of a basement waterproofing system.
A much better solution than seeping onto your basement.
Waterguard channel for basement waterproofing.
This allows groundwater to enter the drain channel.
The waterguard drain outlet is an essential accessory to a typical waterguard installation.
Plus waterguard comes with a 20 year warranty against clogs.
The system drains into a sump pump or other exterior drain keeping the basement dry.
The entire waterguard system must be connected to your sump pump pit.
The waterguard system uses drain pipes installed around the perimeter of the basement which is then covered with concrete.
Hydro channel plus wall and footing drain board interior installation catches water from wall and footing joint.
The wykamol waterguard drainage channel is a pvc drainage conduit for the control of water ingress in below ground waterproofing situations.
It sits above the footer and so will not block with dirt and silt like a drain tile system can.
Wykamol waterguard has a flange up stand and is fitted around the perimeter of the floor at the vulnerable wall to floor junctions directing any ingress of water towards a sump chamber or drain.
Basement waterproofing system advantages.
The base of the drytrak drainage channel is sealed to the basement slab floor with a special epoxy adhesive.
Simply lay the drainage channel on pea gravel in a trough formed in the basement floor.
Water enters the system through channel holes.