You can access the cut settings by clicking on the send tab in silhouette studio.
What are the blade settings for cutting adhesive vinyl.
A 45 degree blade would be good for films that are 2 mil up to around 5 or 6 mil and then a 60 degree blade is good for films that are thicker than 6 mil.
Cut and press settings for products at products cricut setting silhouette setting brother scan cut setting etched vinyl light card stock material.
Weeding means to remove any of the vinyl that you don t want including any insides of the letters.
That said pressure settings are notoriously fickle from cutter to cutter material to material even different lots of the same vinyl can require slightly different pressure settings.
Use this mat when cutting fabric.
Vinyl matte blade 1 speed 5 force 10 blade 3 speed 3 pressure 2.
They then pull up the box around the image and continue to weed from.
After the design is cut it is time to weed the vinyl.
After you make the material type in the send panel the recommended cut settings for vinyl will be displayed.
This is a mat with a high adhesive strength.
Cutting vinyl with a cricut machine.
You need to make sure you text cut every time you change vinyl to avoid wasting materials.
Select images and size and load the mat into the machine.
The same goes for the portrait 2 autoblade.
Refer to kiss cut guide below to adjust machine settings.
Cut weed and apply the vinyl weed the vinyl.
The standard pressure setting for your cutter is 100 for non servo cutters mh sc series laserpoint series titan 1 and 60 for servo cutters titan 2 3.
You also want to make sure you have picked cut which will turn on the cut lines.
Place vinyl liner side down onto cricut standardgrip mat.
Below you ll find cut settings for silhouette cricut and brother scan n cut.
Verify that the tool is set to autoblade cameo 3 or portrait 2 only or the ratchet blade cameo 1 2 portrait.
You can also find a vinyl guide and a sizing guide below.
Standard cut blade turquoise 4.
Card stock plain blade 1 speed 4 force 14 blade 3 speed 3 pressure 3 oracal 631 custom.
Click on blade settings to find all the cut settings you need.
Cut settings can be easiest and trickiest of getting great cut.
One of the most common issues from silhouette cameo beginners is that their cameo 3 autoblade is cutting through the vinyl or other material and the backing.
Some people prefer to add a weeding box around their image when they cut.
You can right click on the images to save them to your computer or you can click the pinterest button in the middle to save them for later.
The tricky news is that each piece of vinyl blade and machine can cut a little differently.
A good rule of thumb is to use a 30 degree blade for films that are in the 1 2 mil range.
